SRW VOC Adhesive

skip to: page content | links on this page | site navigation | footer (site information)

VOC Retaining Wall & Paver Adhesive

PRODUCT CATEGORIES:Adhesives Diamond Blades Earthworks Edging Fabric & Fence Foundation Vents Geogrid Stabilizers/Sealers Stretch Wrap Product Index

Contact our friendly customer service or sales personnel for information.

	SRW VOC Retaining Wall & Paver Adhesive is the highest performing adhesive of its kind. Meets State and Federal VOC regulations. It is formulated especially for masonry, concrete, brick, block, pavers and common landscaping materials. It can be used for bonding frozen, damp surfaces. It exceeds requirements for APA Specification AFG-01, ASTM D3498 and ASTM C557. • Product Info • Directions • User Tips • Safety Sheet (pdf) • Technical Sheet (pdf) • Español (pdf)
PART NUMBER	SIZE	# PER CARTON OR PALLET	LBS
AP10	10.5 oz	12/ctn; 64 ctn/pallet	12/ctn
AP29	29 oz	12/ctn; 38 ctn/pallet	28/ctn
STORE DISPLAY	2 shelves	Holds 24-10.5 oz and/or 18-29 oz. per shelf

PRODUCT INFO	• Interior/Exterior • Ideal for brick, pavers, masonry and concrete • Professional strength adhesive • Use on wet or frozen surfaces • Provides a strong, durable bond COVERAGE: Approximate length of bead according to container size and bead diameter. 10.2 oz cartridge = 1/4" bead, 32 ft; 3/8" bead, 14 ft 29 oz cartridge = 1/4" bead, 89 ft; 3/8" bead 35 ft WORKING TIME: Due to the fast-drying characteristic, once opened use within 30 minutes for 1/4" bead or reseal immediately.

DIRECTIONS	Read product label throughly for important information and warnings. Surface should be clean and free from oil, grease, dust, excessive water or ice, or other loose materials prior to application. The use of other chemicals may deter proper adhesion. Cut tip on slant for 1/4" or 3/8" bead. Puncture inner seal with a nail or wire. Place cartridge in caulking gun and apply on surface with a continuous bead. Apply no more adhesive than you can cover in 20 minutes. Press surfaces together firmly with a slight twisting motion to ensure solid contact. For fast curing, lift the cap, stone, paver or brick straight up to flash (expose adhesive to air) and reset. Do not twist as you lift. To cleanup scrape off dried adhesive with a putty knife. Remove residue with mineral spirits.

USER TIPS	If block, paver, etc., has been tumbled, make sure surface is clean of dust, dirt or material that may deter proper adhesion. Use a 3/8" bead on tumbled products. Best if applied at temperatures above 10º F. Allow 48 hours cure time and 4-5 days after application for heavy traffic. If materials have grooves, make sure you have full positive connection of adhesive to both surfaces. Not made for continuous submersion or use below the waterline. Vertical or slanted applications may require additional bracing until adhesive has dried. Do not smear adhesive or apply with a trowel, due to the fast-drying characteristics. This product is not recommended for fiberglass, rubber, plastic (or like materials). Storage life: More than 12 months in tightly closed container at 75ºF. Do not store in direct sunlight.
RETURN TO TOP

About Us | Index | Privacy Policy | Contact Us | © 2007 SRW Products